Advertisement
Refilling the oil tank:
1.
Be sure to clean the surface around the oil tank cap for not getting dirt inside.
2.
Unscrew the oil tank cap and fill the chainsaw oil (tank capacity 200ml).
3.
Screw on the oil tank cap.
4.
Before start working, check the oil supply: turn on the pruning shears and hold
them over a control place. Inadequate lubrication results in a white mark from
droplets of discharged oil.
WARNING:
a lack of oil for chain lubrication.
Proper lubrication is necessary to reduce chain friction with the tire. The lack of lubrication of
the trimmer reduces productivity and reduces service life, causing rapid wear on the chain
and tire due to overheating. This trimmer is equipped with an automatic lubrication system
that provides the necessary amount of lubricant to the tire and chain. With increasing
engine speed, the oil supply to the tire also increases.
Working techniques
To avoid rupture of the bark and pinching of the tire when trimming thick branches, always
start by making a lightweight cut (1) on the underside. To do this, use a cutting edge and
pull it tangentially through the bottom of the branch. Then make a cross-section.
Facilitated incision. (Fig. 18)
If the branch diameter is more than 10cm, undercut firstly, (3) and cross-section in of total
cutting. Then cut to the end (4). Flat cutting of thick branches. (Fig. 18)
Always check the oil level. Never operate the trimmer with
Fig. 18
Fig. 19
Advertisement
