Table of Contents
Advertisement
Installation Procedure
Do
Mount the thermostat at eye level.
Read the instructions fully so you get the best from our product.
Don't
Do not install near to a direct heat source as this will a ect functionality.
Do not push hard on the LCD screen as this may cause irreparable damage.
This thermostat is designed to be ush mounted and requires a back box of35mm
(minimum depth) to be sunk into the wall prior to installation.
Step 1
Using a small screwdriver, slightly loosen the screw from the bottom face of the
thermostat. You can then carefully separate the front half from the back plate.
Step 2
Place the thermostat LCD front plate somewhere safe.
Terminate the thermostat as shown in the diagrams on pages 26 - 28 of this booklet.
Step 3
Screw the thermostats back plate securely into the back box.
Step 4
Replace the front of the thermostat onto the back plate, by locating the pins in the
socket then insert the top edge rst. Now push in the bottom edge, securing it
in place with the retaining screw.
5
Hide quick links:
Advertisement
Table of Contents
Need help?
Do you have a question about the UFHPROGW and is the answer not in the manual?
Questions and answers
One of my wall thermostats is stuck. Won't edit. Has hand with finger pointing up
The Polypipe UFHPROGW thermostat may be locked if it shows a hand with a finger pointing up. To fix this, try the following steps:
1. Press and hold the Left/Right keys to navigate to the Power Icon.
2. Press and hold the button to turn the display OFF.
3. Press and hold the Down key together with the other relevant key for 10 seconds.
4. The current temperature should appear on the display.
5. If editable, use the Up/Down keys to adjust the settings.
6. Press the confirm button to save changes, and the display should go blank.
If the thermostat remains unresponsive, check the installation and wiring, ensuring it complies with the provided wiring diagrams.
This answer is automatically generated