Table of Contents
Advertisement
Re-calibrating the UFHPROGW
This thermostat is factory set and need not re-calibrating under normal operation!
To calibrate, follow the step below.
• Use the 'Left/Right' keys to scroll to the Power Icon ........................................
• Press and hold
• Press and hold the
The current temperature will appear on the display.
• Use the 'Up/Down' keys to con gure the new temperature value .............
• Press the
key to con rm the change and the display will go blank ....
• Press the
key once to turn the thermostat 'ON' ............................................
Error Codes
UFHPROGW
The
will display an error code if there is a fault with the temperature
sensor, these error codes are explained below.
E0 = The internal sensor has developed a fault.
E1 = The remote FLOOR probe has not been connected.
The remote FLOOR probe has not been wired correctly.
The remote FLOOR probe is faulty.
25
to turn the display 'OFF' ..........................................................
and 'Down' keys together for 10 seconds .................
Hide quick links:
Advertisement
Table of Contents
Need help?
Do you have a question about the UFHPROGW and is the answer not in the manual?
Questions and answers
One of my wall thermostats is stuck. Won't edit. Has hand with finger pointing up
The Polypipe UFHPROGW thermostat may be locked if it shows a hand with a finger pointing up. To fix this, try the following steps:
1. Press and hold the Left/Right keys to navigate to the Power Icon.
2. Press and hold the button to turn the display OFF.
3. Press and hold the Down key together with the other relevant key for 10 seconds.
4. The current temperature should appear on the display.
5. If editable, use the Up/Down keys to adjust the settings.
6. Press the confirm button to save changes, and the display should go blank.
If the thermostat remains unresponsive, check the installation and wiring, ensuring it complies with the provided wiring diagrams.
This answer is automatically generated