Phoenix Contact Axioline F AXC Series User Manual page 18

UM EN AXL F SYS DIAG
Table 2-1 Error codes for user errors [...]
Code Additional code
(hex)
093B Incorrect Vari-
able_Count
0A01
0A02 Current status of the
local bus master
0A03
0A04
0A05
0A06
0A07
0A08 Code of failed service
0A0C Unknown Variable_ID
18
PHOENIX CONTACT
Meaning
The number of variables has been calculated incor-
rectly.
A hardware or firmware error occurred.
A service was called that is not permitted in the current
status of the local bus master.
Possible states:
Ready 
0001
(After restart or reset)
0002 Load Config
(Configuration cannot be loaded)
0004 Config Ready
(Configuration loaded successfully)
0008 Active
(Configuration frame connected)
0010
Param Ready
(Parameterization of modules completed)
0020 Run
(Process data traffic running)
0080 Force Mode
(Startup tool specifies outputs)
0100 Ready Fail
(Communication abort in Ready)
Active Fail 
0800
(Communication abort in Active)
1000 Param Ready Fail
(Communication abort in Ready parameter)
Run Fail 
2000
(Process data traffic with subsystem)
4000 Force Fail
(Application timeout for all devices)
Force Mode Fail 
8000
(Communication abort in Force_Mode)
Memory problem (e.g., buffer too small)
Inconsistent parameters
Invalid parameters
Access not supported.
Object does not exist.
Maximum number of permitted parallel SM services ex-
ceeded. (Processing conflict)
Call of Set_Value or Read_Value with a Variable_ID that
contains an unknown code.
Remedy
Check the call.
Restart the device. If the
problem still occurs, please
contact Phoenix Contact.
Set the local bus master to
the required state.
Restart the device. If the
problem still occurs, please
contact Phoenix Contact.
Check the call.
Check the call.
Check the call.
Check the call.
Wait for the service called
previously to be completed,
and then try again.
Check the call.
8663_en_03