Startup Messages - 3Com CS/2500 Installation Manual

B
S
TARTUP
At power-on or reset, the server performs self-tests and diagnostics.
When a console is attached and monitor mode is enabled, it sends status
and error messages generated by these tests to the console, if possible.
This appendix lists these messages in alphabetical order.
The server may not always be able to report a failure on the console (for
example, CPU failure).
If you receive an error message, refer to Chapter 6, "Troubleshooting."
If you still receive an error message, contact 3Com or your network
supplier. Refer to Appendix D, "Technical Support," for technical
support information.
3Com Series/2000 Monitor
Meaning: The server is in monitor mode.
CPU - Failed Test # x
Meaning: An error was encountered in CPU test x.
CPU - Passed C3 MMON rev. <xxx>
Meaning: No errors were encountered in CPU self-tests. The server's
firmware revision is <xxx>.
EC - Failed Test # <x>
Meaning: An error was encountered in Ethernet controller test <x>.
EC - Passed Station Address - <xxxxxxxxxxxx>
Meaning: No errors were encountered in Ethernet controller tests. The
server's Ethernet address is <xxxxxxxxxxxx>.
Series/2000 Power-up
Meaning: Self-tests have begun.
M
ESSAGES