3Com CS/2500 Installation Manual page 53

Table 4-1 Firmware Configuration Parameters (continued)
Parameter
(continued)
4. Auto-reboot
5. Monitor
6. Initial boot source
7. Number of reboots
8. Network boot string
9. Boot retries
A. Boot protocol
B. Change IP/TFTP parameters
P. Printer setup menu
S. System default configuration
menu
* Default.
† Default for CS/2500.
‡ CS/2600 only. Default is Floppy then Network.
** Choosing TFTP adds a choice to the Change Parameters menu. For more information, see
"Using TFTP" on page 4-9.
Changing the Configuration
Values
m - Boot monitor
u - Upload then reboot
r - Reboot only *
*
d - Disable
e - Enable
1 - Network †
2 - Monitor
3 - Local Floppy ‡
4 - Network then Floppy
5 - Floppy then Network
Reset reboots number
r - reset
_cs200 *
0 - Try One Time
*
F - Try Forever
B - BTP Boot
S - SLP Boot *
T - TFTP Boot **
This option appears only when the boot
protocol is TFTP. See "Using TFTP" on
page 4-9.
1 - Issue a LF after CR
2 - Do not issue a LF after CR
3 - Add a printer setup string
4 - Delete printer setup string
1 - Change default memory map to
CS/2000/2100
2 - Configure port(s) as RS-232
3 - Configure port(s) as RS-422
4 - Enable/Disable automatic RS-422 port
selection (pin 25)
4-5
‡
‡