Changing The Configuration - 3Com CS/2500 Installation Manual

Changing the
Configuration
To change the communications server configuration, follow this
procedure:
1 Enter the firmware configuration command
The following menu is displayed:
Firmware Configuration Utility
Commands:
C - Change parameters
D - Display parameters
es - Exit to monitor
c
2 Type to display current parameter settings.
D
The following display shows factory default settings for the CS/2600
(except for Ethernet address, which is only an example):
Ethernet address
Console baud rate
Console port
Continuous self-test
Auto-reboot
Monitor
Initial boot source
Number of reboots
Network boot string
Boot retries
Boot protocol
Number of ports
Default memory map
RS-232 ports
RS-422 ports
Auto RS-422 select
LF issued after CR
Printer setup string:
Default settngs for the CS/2500 are the same, except that Initial Boot
Source is "Network."
3 To return to the Firmware Configuration Utility menu, press the Return
key.
Current Parameters:
080002025DAC
9600
0
Disabled
Reboot only
Disabled
Floppy then Network
00
_cs200
Try Forever
SLP
10
CS/2500/2600
0 1 2 3 4 5 6 7 8 9
Disabled
YES

Changing the Configuration

at the monitor prompt.
fc
4-3