Console Baud Rate; Console Port; Auto-Reboot; Monitor - 3Com CS/2500 Installation Manual

4-4 C 4: C
HAPTER ONFIGURATION
4 To change the current parameters, type
The Change Parameters menu appears:
Current Parameters:
1.

Console baud rate

2.

Console port

3. Continuous self-test
4.

Auto-reboot

5.

Monitor

6. Initial boot source
7. Number of reboots
8. Network boot string
9. Boot retries
A. Boot protocol
P. Printer setup menu
S. System default configuration menu
esc Return to previous menu
5 Type the number or letter for the parameter you want to change.
Table 4-1 describes each parameter and the choices available. More
detailed descriptions of each parameter follow this table.
6 When you are finished changing firmware configuration parameters,
press the Escape key to return to the Firmware Configuration Utility
menu.
7 Press the Escape key again to exit to the monitor prompt.
8 Press the reset switch or turn off the server to exit monitor mode.
Table 4-1 Firmware Configuration Parameters
Parameter
1. Console baud rate
2. Console port
3. Continuous self-test
.
C
9600
0
Disabled
Reboot only
Disabled
Floppy then Network
00
_cs200
Try Forever
SLP
Values
0. 110
1. 300
2. 1200
3. 2400
*
4. 9600
0 * –9
d - Disable *
e - Enable