3Com CS/2500 Installation Manual page 101

The <filename> and <address> parameters specify the name of the
bootfile and the location in memory where it should be loaded. For
example, enter
from memory location 0x4000010.
If you do not specify a parameter, the server attempts to boot from file 0
on the diskette.
CO
Syntax
CO
Copies the contents of a diskette to one or more diskettes (Model
Description
CS/2600 only). For a description of the procedure, refer to "Copying and
Formatting Diskettes" on page 3-4.
DE
Syntax
DE <filenumber>
Deletes the specified file from the diskette (Model CS/2600 only). Valid
Description
entries are 0 through 9. For example, enter
diskette.
DF
Syntax
DF
Lists files on the diskette (Model CS/2600 only), including start and end
Description
blocks, length of the file, and starting address.
DU
Syntax
DU
Dumps the server's memory to a set of diskettes (Model CS/2600 only).
Description
For information about memory dumps, refer to "Memory Dump
Procedures" on page 6-5.
FC
Syntax
FC
Enters the Firmware Configuration Utility menu. For information on
Description
using this menu, refer to Chapter 4, "Configuration."
bt _cs30 0x4000010
Using Commands
to load and run the file _cs30
to delete file 2 from the
de 2
C-5