Setup Menu - OHAUS Scout SKX Series Instruction Manual

EN-8

4.3 Setup Menu

Enter this menu to set balance parameters.
Reset:
Filter:
Auto Zero Tracking:
Stable:
Backlight:
Auto Tare:
Auto Off:
End Setup:
Note: Bold always represents factory default value.
Reset [r r eset]
Reset the Setup menu to factory defaults.
NO = not reset
YES = reset
Filter [FiLtEr]
Set the amount of signal filtering.
LOW
MED
HI
AZT [AZt]
Set the automatic zero tracking functionality.
OFF
0.5d
1d
3d
Stable Range [Stable]
Set the amount the reading can vary while the stability symbol remains on.
0.5d
1d
2d
5d
Back Light [b.Light]
Sets backlight functionality.
OFF
ON
AUTO
Note: When connected with power pack, the backlight is always on.
Auto Tare [A.tArE]
Set the automatic tare functionality.
OFF
ON
ON-ACC = stable gross loads within the accept limits are tared (in Check weighing mode)
Find Quality Products Online at:
no, yes
Low, Med, High
off, 0.5d, 1d, 3d
0.5d, 1d, 2d, 5d
off, on, auto
off, on, on-acc
off, 1, 5, 10
Exit menu
= less stability, faster stabilization time
= normal stability, stabilization time
= greater stability, slower stabilization time
= disabled
= the display will maintain zero until a change of 0.5 division per second has
been exceeded.
= the display will maintain zero until a change of 1 division per second has been
exceeded.
= the display will maintain zero until a change of 3 divisions per second has been
exceeded.
= 0.5 balance division
= 1 balance division
= 2 balance divisions
= 5 balance divisions
= always off
= always on
= turns on when a button is pressed or the displayed weight changes.
= Automatic Tare is disabled
= the first stable gross weight is tared
GlobalTestSupply
www.
TM
SCOUT SERIES BALANCES - SKX
.com
sales@GlobalTestSupply.com