Setup Menu; Reset [Reset] - OHAUS Ranger Count RC1P1502 Instruction Manual

Ranger™ Count 3000 Series

4.3 Setup Menu

Enter this menu to set scale parameters. Default settings are in bold.
Reset:
Dual Scale:
Cap2:
Grad2:
Power on unit:
Zero Range:
Auto Opt:
Auto Tare:
Beeper Opt:
Beeper Signal:
Beeper Key:
Accumulation:
End Setup:

Reset [reset]

Reset the Setup menu to factory defaults.
NO = not reset
YES = reset
Dual Scale [d.scale]
Set the status of the second scale input (Scale 2).
OFF = disabled
ON = enabled
Cap2 [CAP2]
Set the capacity of Scale 2.
1...9999
Grad2 [GrAd2]
Set the readability of Scale 2.
0.00005...0.5
Power on unit [pwWr.UN]
Set the unit of measure displayed at startup.
AUTO = last unit in use when turned off
kg = kilograms
g = grams
lb = pounds
oz = ounces
lb:oz = pound ounces
Zero Range [ZErO]
Set the percentage of scale capacity that may be zeroed.
2% = zero up to 2 percent of capacity
10% = zero up to 10 percent of capacity
Auto Opt [A.OPt]
Set the Automatic Optimization.
OFF = disabled
ON = APW automatically optimized
no, yes
off, on
1...9999
0.00005...0.5
auto, kg, g, lb, oz, lb:oz
2%, 10%
off, on
on, off, on-acc
off, on
off, accept, under, over, under-over
off, on
off, auto, manual
Exit menu
EN-15