Setup Menu - OHAUS Ranger 4000 Count Series Instruction Manual

Ranger 4000 Count Series
Zero2:
Span1:
Span2:
Linearity1:
Linearity2:
Geographic
Adjustment:
End Calibration: Exit menu
*Bold always represents factory default value.
Zero2 [
nd
Initiates a 2
Span1 [
Initiates a span calibration procedure (zero and span). A span calibration is important when
initially setting up the scale.
Span2 [
nd
Initiates a 2
Lin1 [ ]
Initiates a linearity calibration procedure (zero, mid-point and span).
Lin2 [ ]
nd
Initiates a 2
GEO [ ]
Geographical Adjustment Factor (GEO) is used to adjust the calibration based on the current
location. Settings from 0 to 31 are available with 12 being the default. Refer to table 4-2 to
determine the GEO factor that corresponds to your location.
End Cal [
Advance to the next menu or return to the top of the current menu.

4.3 Setup Menu

Enter this menu to set scale parameters.
Reset:
Dual Scale:
Cap2:
Grad2:
Power on unit:
Zero Range:
Auto Opt:
Auto Tare:
Beeper Opt:
Beeper Signal:
Beeper Key:
Accumulation:
Find Quality Products Online at:
Perform
Perform
Perform
Perform
Perform
Set 0 12 *
]
scale zero calibration.
]
]
scale span calibration procedure.
scale linearity calibration procedure.
]
no, yes
off, on
1
auto, kg, g, lb, oz, lb:oz
2%, 10%
off, on
on, off, on-acc
off, on
off, accept, under, over, under-over
off, on
GlobalTestSupply
off, auto, manual
www. .com
sales@GlobalTestSupply.com
EN 13