Chapter 2: Removing And Installing Components; Recommended Tools; Screw List - Dell XPS 13 9310 Service Manual

Removing and installing components
NOTE: The images in this document may differ from your computer depending on the configuration you ordered.

Recommended tools

The procedures in this document may require the following tools:
● Phillips screwdriver #0
● Phillips screwdriver #1
● Torx #5 (T5) screwdriver
● Plastic scribe

Screw list

NOTE: When removing screws from a component, it is recommended to note the screw type, the quantity of screws, and
then place them in a screw storage box. This is to ensure that the correct number of screws and correct screw type is
restored when the component is replaced.
NOTE: Some computers have magnetic surfaces. Ensure that the screws are not left attached to such surfaces when
replacing a component.
NOTE: Screw color may vary with the configuration ordered.
Table 1. Screw list
Component Secured to
Base cover Palm-rest and keyboard
assembly
Battery Palm-rest and keyboard
assembly
Solid-state drive shield System board
Fans (in computers System board
shipped with
computers shipped
th
with 11 Generation
Intel Core i3-1115G4
processor)
Heat sink (in System board
computers shipped
with computers
th
shipped with 11
Generation Intel Core
i3-1115G4 processor)
8 Removing and installing components
Screw type Quantity
M2x3, Torx 5 8
M1.6x2.5 5
M2x3 1
M1.6x2.5 4
M2x3 (captive) 4
2
Screw image