Installing The Heat-Sink And Fan Assembly - Dell XPS 13 9310 Service Manual

About this task
NOTE: This procedure applies to computers shipped with 11
Intel Core i7-1165G7 processor. The heat sink and the fans are combined in a heat-sink and fan assembly.
The following image indicates the location of the heat-sink and fan assembly and provides a visual representation of the removal
procedure.
Steps
1. In reverse sequential order (as indicated on the heat-sink and fan assembly), loosen the four captive screws (M2x3) that
secure the heat-sink and fan assembly to the system board.
2. Peel the tapes that secure the fan cables to the system board.
3. Disconnect the fan cables from the system board.
4. Remove the four screws (M1.6x2.5) that secure the fans to the system board.
5. Lift the heat-sink and fan assembly off the system board.

Installing the heat-sink and fan assembly

Prerequisites
If you are replacing a component, remove the existing component before performing the installation procedure.
NOTE: This procedure applies to computers shipped with 11
Intel Core i7-1165G7 processor. The heat sink and the fans are combined in a heat-sink and fan assembly.
CAUTION: Incorrect alignment of the heat-sink and fan assembly can damage the system board and processor.
NOTE: If either the system board or the heat-sink and fan assembly is replaced, use the thermal pad/paste provided in the
kit to ensure that thermal conductivity is achieved.
About this task
The following image indicates the location of the heat-sink and fan assembly and provides a visual representation of the
installation procedure.
th
Generation Intel Core i5-1135G7 processor or 11
th
Generation Intel Core i5-1135G7 processor or 11
Removing and installing components
th
Generation
th
Generation
27