Installing The Status-Light Board; Palm-Rest And Keyboard Assembly; Removing The Palm-Rest And Keyboard Assembly - Dell XPS 13 9310 Service Manual

Installing the status-light board

Prerequisites
If you are replacing a component, remove the existing component before performing the installation procedure.
About this task
The following image indicates the status-light board and provides a visual representation of the installation procedure.
Steps
1. Place the status-light board into its slot on the palm-rest and keyboard assembly.
NOTE: Ensure that the right side of the status-light board is aligned with the peg on the palm-rest and keyboard
assembly.
2. Connect the status-light board cable to the keyboard-control daughterboard on the palm-rest and keyboard assembly and
close the latch to secure the cable.
Next steps
1. Install the battery.
2. Install the base cover.
3. Follow the procedure in

Palm-rest and keyboard assembly

Removing the palm-rest and keyboard assembly

Prerequisites
1. Follow the procedure in
2. Remove the base cover.
3. Remove the battery.
4. Remove the display assembly.
5. Remove the system board.
After working inside your
Before working inside your
computer.
computer.
Removing and installing components 41