Removing The M.2 2280 Solid-State Drive - Dell XPS 13 9310 Service Manual

NOTE: This procedure applies only if you are installing an M.2 2230 solid-state drive.
The following image indicates the location of the M.2 2230 solid-state drive and provides a visual representation of the
installation procedure.
Steps
1. Align the notch on the M.2 2230 solid-state drive with the tab on solid-state drive slot on the system board.
2. Slide the M.2 2230 solid-state drive into solid-state drive slot on the system board.
3. Insert the notch on the solid-state drive shield into a slot on the peg on the system board.
4. Replace the screw (M2x3) that secures the M.2 2230 solid-state drive shield to the system board.
5. Route the antenna cable through the routing guides along the solid-state drive shield.
Next steps
1. Install the base cover.
2. Follow the procedure in

Removing the M.2 2280 solid-state drive

Prerequisites
1. Follow the procedure in
CAUTION: Solid-state drives are fragile. Exercise care when handling the solid-state drive.
After working inside your
Before working inside your
computer.
computer.
Removing and installing components 19