Dell XPS 13 9310 Service Manual page 49

Table 5. System setup options—Integrated Devices menu (continued)
Integrated Devices
Enable Thunderbolt (and PCIe behind TBT)
pre-boot modules
Miscellaneous Devices
Enable Fingerprint Reader Device
Enable Fingerprint Reader Single Sign On
Table 6. System setup options—Storage menu
Storage
SATA/NVMe Operation
SATA/NVMe Operation
Storage Interface
Port Enablement
Drive Information
Enable MediaCard
Table 7. System setup options—Display menu
Display
Display Brightness
Brightness on battery power
Brightness on AC power
Touchscreen
Touchscreen
Full Screen Logo
Full Screen Logo
Enables or disables to allow or disallow PCIe devices to be connected through a
Thunderbolt adapter during pre-boot.
Default: OFF
Enables or disables the Fingerprint Reader Device.
By default, Enable Fingerprint Reader Device is selected.
Enables or disables the Fingerprint Reader Device's Single Sign On capability.
By default, Enable Fingerprint Reader Device's Single Sign On capability is
selected.
Configures operating mode of the integrated SATA hard drive controller.
Default: AHCI/NVMe. Storage device is configured for AHCI/NVMe mode.
Displays the information of various onboard drives.
Enables or disables the M.2 PCIe SSD.
Default: ON
Displays the information of onboard drives.
Enables to switch all media cards On/Off or set the media card to read-only
state.
By default, Enable Secure Digital (SD) Card is selected.
Sets the screen brightness when the computer is running on battery power.
Default: 50
Sets the screen brightness when the computer is running on AC power.
Default: 100
Enables or disables the touchscreen.
Default: ON
Enabled or disabled the computer to display full screen logo if the image match
screen resolution.
Default: OFF
System setup 49