Bio X System Warnings; Thermoplastic Printhead Warnings - Cellink BIO X User Manual

03 Safety information

3.1 BIO X system warnings

• Please consult the BIO X manual for BIO X-specific warnings and safety procedures.

3.2 Thermoplastic Printhead warnings

• Clean the printhead using instructions in the Maintenance section. Do not clean the
printhead by submerging it in liquid or using excessive spraying. Liquid inside the printhead
can damage the circuitry and motor.
• The Thermoplastic Printhead operates at very high temperatures. The LED on the printhead
will turn yellow to indicate a warm printhead and red to indicate a hot printhead. Do not
touch the printhead when the LED is red. Touching a hot printhead risks serious injury.
• Only load the cartridge with dry thermoplastic granulate. Ensure the cartridge is clean
and dry before loading the granulate. Only use the cartridge with CELLINK-supplied
thermoplastic granulates or granulates from our recommended suppliers.
• Load and unload the Thermoplastic Printhead onto the BIO X printhead mounts using
guidelines in the Getting Started section. Do not pull or push the printhead with excessive
force while it's loaded on the BIO X. Using excessive force risks damaging the motor and its
guides.
8