Bio X System Warnings; Temperature-Controlled Printhead Warnings - Cellink BIO X User Manual

03 Safety information

3.1 BIO X system warnings

• Please consult the BIO X manual for BIO X-specific warnings and safety procedures.

3.2 Temperature-controlled Printhead warnings

• DO NOT clean the printhead by submerging it in liquid or using excessive spraying. Liquid inside the printhead can damage the circuitry and
motor.
• The LED on the printhead will turn yellow to indicate a warm printhead and red to indicate a hot printhead. Do not touch the printhead when
the LED is red. Touching a hot printhead risks serious injury.
• DO NOT manually move the printhead mount. Moving the printhead mount manually will damage the motor. If the mount needs to be moved,
place the printhead in the loading position described in the Getting Started section.
• The Temperature-controlled Printhead can be hot to the touch after use. DO NOT touch the foils when the printhead is heating or cooling.
• DO NOT manually move the printhead mount. Moving the printhead mount manually will damage the motor. If the mount needs to be moved,
place the printhead in the loading position described in the Getting Started section.
• Use the proper method to load and unload the EMD Printhead onto the BIO X printhead mounts. Instructions are outlined in the Getting
Started section. While loaded on the BIO X, do not pull or push the printhead with excessive force, especially when the BIO X system is turned
on. Doing so will damage the motor and its guides.
• DO NOT use a jerking motion to remove the printhead. Using a jerking motion risks hitting and damaging the HEPA filter.
• DO NOT place fingers on the printhead while it is in motion. Users risk serious, permanent injury if fingers are caught between the printhead
base and the motor arm.
• The cooling fan of the Temperature-controlled Printhead is exposed to allow for heat dissipation. DO NOT put fingers or other objects into the
fan while the printhead is in operation. Doing so risks injury and damage to the printhead.
cooling.
8