Table of Contents
Advertisement
Setting Up Monitoring Using SNMP
Network administrators can install SNMP (Simple Network Management
Protocol) software on network computers so they can monitor projectors. If
your network uses this software, you can set up the projector for SNMP
monitoring.
a
Press the [Menu] button, select the Network menu, and press [Enter].
b
Select Network Settings and press [Enter].
c
Select the Projector Control menu and press [Enter].
d
Set the SNMP setting to On.
e
Enter up to two IP addresses to receive SNMP notifications, using 0 to
255 for each address field.
Do not use these addresses: 224.0.0.0 through 255.255.255.255.
This projector supports SNMP agent version 1 (SNMPv1).
a
f
Enter the SNMP Community Name up to 32 alphanumeric characters
long.
g
When you finish selecting settings, go back to the Network Settings
screen, select Set, and follow the on-screen instructions to save your
settings and exit the menus.
155
Advertisement
Table of Contents
