Setting Up Monitoring Using Snmp - Epson EB-810E User Manual

Setting Up Monitoring Using SNMP

Network administrators can install SNMP (Simple Network Management
Protocol) software on network computers so they can monitor projectors.
If your network uses this software, you can set up the projector for SNMP
monitoring.
a
Press the [Menu] button, select the Network menu, and press [Enter].
b
Select Network Settings and press [Enter].
c
Select the Projector Control menu and press [Enter].
d
Set the SNMP setting to On.
e
If no SNMP Community Name has been set, a screen prompting you to
set a Community Name is displayed. Enter an SNMP Community Name.
You can enter up to 32 alphanumeric characters.
f
Enter up to two IP addresses to receive SNMP notifications as the Trap IP
Address 1 and Trap IP Address 2 settings, using 0 to 255 for each address
field.
Do not use these addresses: 224.0.0.0 through 255.255.255.255. This
projector supports SNMP agent version 1 (SNMPv1).
g
When you finish selecting settings, go back to the Network Settings
screen, select Set, and follow the on-screen instructions to save your
settings and exit the menus.
177