Setting Up Monitoring Using Snmp - Epson CO-FD01 User Manual

Setting Up Monitoring Using SNMP

Network administrators can install SNMP (Simple Network Management
Protocol) software on network computers so they can monitor projectors. If
your network uses this software, you can set up the projector for SNMP
monitoring.
a button on the remote control, select the Network menu,
Press the
and press [Enter].
b Select Network Configuration and press [Enter].
c Select the Notifications menu and press [Enter].
d Set the SNMP setting to On.
Enter up to two IP addresses to receive SNMP notifications as the Trap
e
IP Address 1 and Trap IP Address 2 settings, using 0 to 255 for each
address field.
Do not use these addresses: 224.0.0.0 through 255.255.255.255.
This projector supports SNMP agent version 1 (SNMPv1).
a
f Enter the SNMP Community Name up to 32 alphanumeric characters
long.
g When you finish selecting settings, select Complete and follow the on-
screen instructions to save your settings and exit the menus.
75