Sharp AQUOS SH-02L Instruction Manual page 76

1
In the standby screen,
[Wi-Fi]
2
[Wi-Fi]▶Set to ON
3
Select an access point
z If you select an access point protected by security,
enter the password (security key) and select
[Connect].
z To register access points manually: [Add network]
▶enter the network name▶set security▶[Save]
z When you select [Saved networks], the access
point that you have accessed is displayed.
When you connect to Wi-Fi network, [Connected] is
z
displayed.
When a different message is displayed, make sure the
password (security key).
When the connection is not established even if you
enter a correct password (security key), the correct IP
address may not have been acquired. Connect to the
access point again after confirming signal status.
As for the manual registration of an access point, this
z
function supports WEP, WPA/WPA2 PSK and
802.1xEAP as the security setting.
z▶[Settings]▶
If you connect to an access point which is not
z
connected to the Internet, [
communication may be made by mobile networks, not
Wi-Fi connection.
To make Wi-Fi communication by using such an
access point, disable [Wi-Fi preferences]▶[Avoid poor
connections]
Wi-Fi settings
„
1
In the standby screen,
[Wi-Fi]
2
[Wi-Fi preferences]
3
Select an item
Open network
„
notification icon when an open network is detected.
z Set it after setting [Wi-Fi] to On.
Avoid poor connections: Set whether to use the
„
Wi-Fi function only when stable Internet
connections are available.
Install certificates: Install certificates.
„
Wi-Fi Direct: For details
„
WPS Push Button: Set the Wi-Fi with WPS Push
„
Button.
z Push the WPS button of the access point. An
access point is detected automatically and
starts registration.
74
] is displayed and the
z▶[Settings]▶
notification: Set whether to display a
☞
P. 75 "Wi-Fi Direct"
Before Using the Handset