Sharp AQUOS SH-02L Instruction Manual page 162

Setting an access point
„
An access point (sp-mode) for Internet connection is
registered by default. You can add other access points
and change them if necessary.
For details of sp-mode, refer to the NTT DOCOMO
website.
h ttps://www.nttdocomo.co.jp/service/spmode/ (in (
Japanese only))
If you want to use mopera U or Business mopera Internet,
add an access point of either provider manually.
For details on mopera U, refer to the mopera U website.
( h ttps://www.mopera.net/ (in Japanese
1
In the standby screen,
[Network]▶[Mobile network]▶[Access
Point Names]
z You can check an access point in use.
2
z▶[New APN]
3
[Name]▶enter the name of the network
profile to create▶[OK]
4
[APN]▶enter the access point name▶[OK]
5
Enter other items required by network
operators▶z▶[Save]
z Never set the MCC to a figure other than 440 or
the MNC to a figure other than 10. Otherwise the
added access point disappears from the screen.
only))
z▶[Settings]▶
If the settings of MCC and MNC are changed and the
z
added access point disappears from the screen, reset
the settings or set the access point manually.
Resetting an access point
„
Return the access point settings to the initial state.
1
In the standby screen,
[Network]▶[Mobile network]▶[Access
Point Names]
2
z▶[Reset to default]
When sp-mode is not subscribed or if you fail to make
z
automatic setting of an access point due to signal
status such as outside the service area, you are
required to set the access point again manually.
Data usage
You can check the data usage volume via mobile
networks or Wi-Fi networks. Also, you can set limit.
1
In the standby screen,
[Network]▶[Data usage]
z The data communication volume via mobile
networks is displayed.
160
z▶[Settings]▶
z▶[Settings]▶
Handset Settings