Sharp AQUOS SH-02L Instruction Manual page 204

y Is an adapter specified by NTT DOCOMO being used
for charging? Contact the number listed in
"Troubleshooting & Repairs" (in Japanese only) on
the last page or a repair counter that DOCOMO
specifies if you cannot charge the battery even when
using a specified one.
Handset operation
„
z Becomes hot while operating/charging
y The handset, battery pack, or adapter may become
warm while you are operating or charging the
handset or while you are, for example, watching TV
for a long time during charging, etc. There is no
operational problem.
charging"
z Battery life is short
y Make sure the handset is not left for a long time
outside the service area. Outside the service area,
since radio waves are searched to make
communication available, more electric power than
usual is used.
y The battery life depends on the usage environment
and deterioration level.
specifications"
y Battery pack is a consumable product. Battery life
per charge is gradually reduced every time the
battery is charged. If the battery life becomes
extremely shorter than at the time of purchase even
after fully charged, purchase a new specified battery
☞
pack. P. 59 "Battery pack usable life"
☞
P. 59 "Cautions while
☞
P. 213 "Main
z Unintended handset power off or restart occurs
y When the terminal of battery pack is dirty, the
connection become bad and the handset may turn
off. If it is dirty, clean the terminal of the battery pack
with a dry cotton swab etc.
y Is IC area of docomo nano UIM card dirty?
☞
P. 50 "docomo nano UIM card"
z Not activated by pressing keys
y Make sure the handset is not turned off.
"Turning power on"
z Screen response is slow when pressing keys
y This may happen when a great deal of data is saved
on the handset, when a large amount of data is
being transferred between the handset and the
microSD Card, etc.
z docomo nano UIM card is not recognized
y Is the docomo nano UIM card inserted facing right
☞
direction? P. 50 "docomo nano UIM card"
z Clock is incorrect
y Clock may become incorrect if the power is left
turned on for a long time. Make sure [Automatic date
& time] is enabled and turn the power on again in a
location with good signal conditions.
"Date & time"
202
☞
☞
P. 165 "Storage"
☞
P. 164
Appendix/Index
P. 64