Backwashable Filter System Setup - Water Depot ECONO Series Owner's Manual

Backwashable Filter System Setup - Econo
In Filter System Setup choose the time for the cycles selected in Cycle Sequence and specifies other operating
parameters for the system. The upper and lower limits of the allowable values for the cycles are as follows:
Backwash
Rinse (fast)
dn Brine (combination of regenerant and slow rinse)
UP Brine (combination of regenerant and slow rinse)
Fill
Service
NOTE: Fill is in gallons.
Since no time is associated with the END cycle, the END cycle will not appear in the Filter System Setup sequence.
Step 1F – Press NEXT and  simultaneously for 3 seconds and release. If screen in Step 2F
does not appear in 5 seconds the lock on the valve is activated. To unlock press , NEXT, ,
and CLOCK in sequence, then press NEXT and simultaneously for 3 seconds and release.
Step 2F – Choose FILTERING using the  or  buttons. Press NEXT to go to Step 3F.
Press REGEN to exit Filter System Setup.
Step 3F – Select the time for the first cycle (which in this example is BACKWASH) using the
 or  button. Press NEXT to go to Step 4F. Press REGEN to return to previous step.
Step 4F – Select the time for the second cycle (which in this example is dn BRINE) using the
 or  button. Press NEXT to go to Step 5F. Press REGEN to return to previous step.
NOTE: The display will flash between cycle number and time, and brine direction (dn or UP).
Step 5F – Select the time for the third cycle (which in this example is RINSE) using the  or
 button. Press NEXT to go to Step 6F. Press REGEN to return to previous step.
Step 6F – Select the gallons for the fourth cycle (which in this example is FILL) using the  or
 button. Press NEXT to go to Step 7F. Press REGEN to return to previous step.
STEP 2F
STEP 3F
STEP 4F
STEP 5F
Cycle Options Units Lower/Upper Limit
Minutes 1 to 120
Minutes 1 to 120
Minutes 1 to 180
Minutes 1 to 180
Minutes 0.01 to 20.00
Minutes 1 to 480
Default
8
4
60
60
0.95
240
8