Installer Display Settings; Softener System Setup - Water Depot PLATINUM SERIES Owner's Manual

Hide thumbs Also See for PLATINUM SERIES:

Owner's manual (17 pages)

Table Of Contents

Table of Contents

STEP 1I - Press NEXT and  simultaneously for 3 seconds.

STEP 2I – Hardness: Set the amount of hardness in grains of hardness as calcium

carbonate per gallon using the  or  buttons. The default is 20 with value ranges

from 1 to 150 in 1 grain increments. Note: The grains per gallon can be increased if

soluble iron needs to be reduced. This display will show "–nA–" if "FILTER" is selected

in Step 2F or if 'AUTO' is not selected in Set Volume Capacity in Softener System

Setup. Press NEXT to go to step 3I. Press REGEN to exit Installer Display Settings.

STEP 3I – Day Override: When volume capacity is set to "oFF", sets the number of days

between regenerations. When volume capacity is set to AUTO or to a number, sets the

maximum number of days between regenerations. If value set to "oFF", regeneration

initiation is based solely on volume used. If value is set as a number (allowable range

from 1 to 28) a regeneration initiation will be called for on that day even if sufficient

volume of water were not used to call for a regeneration. Set

Day Override using  or  buttons:

• number of days between regeneration (1 to 28); or

• "oFF".

See Table 8 for more detail on softener setup and Table 9 for more detail on filter setup.

Press NEXT to go to step 4I. Press REGEN to return to previous step.

STEP 4I – Next Regeneration Time (hour): Set the hour of day for regeneration using

 or  buttons. AM/PM toggles after 12. The default time is 2:00 AM. This display

will show "on 0" if "on 0" is selected in Set Regeneration Time Option in Softener

System Setup or Filter System Setup. Press NEXT to go to step 5I. Press REGEN to

return to previous step.

STEP 5I – Next Regeneration Time (minutes): Set the minutes of day for regeneration

using 

Regeneration Time Option in Softener System Setup or Filter System Setup. Press

NEXT to exit Installer Display Settings. Press REGEN to return to previous step.

To initiate a manual regeneration immediately, press and hold the "REGEN" button for

three seconds. The system will begin to regenerate immediately. The control valve may

be stepped through the various regeneration cycles by pressing the "REGEN" button.

In Softener System Setup the chooses the time for the cycles selected in Cycle Sequence and species other

operating parameters for the system. The upper and lower limits of the allowable values for the cycles are as

follows:

Cycle Options

Backwash

Rinse (fast)

dn Brine (combination of brining and slow rinse)

UP Brine (combination of brining and slow rinse)

Fill

Service

Note: Fill is in pounds of salt.

Since no time is associated with the END cycle, the END cycle will not appear in the Softener System Setup

sequence.