Table of Contents
Advertisement
automatically when
UP and DOWN buttons
are depressed and held
7. Control valve does not
regenerate
automatically but does
when UP and DOWN
buttons are depressed
8. Smell and/or Iron
bleeding thru
9. Smell Hot side only
10. Black or Grey water
(cold side)
12. Excessive noise
during backwash
13. Particles in water
(Media-Black)
c. Broken drive gear or drive cap
assembly
d. Defective PC board
a. Defective PC board
b. Set-up error
c. Replace drive gear or drive cap
assembly
d. Replace PC board
a. Replace PC board
b. Check control valve set-up procedure
a. Size of equipment correct
b. Check media
a. Chlorinate hot tank
b. Optional to remove anode rod.
c. If condition persists check for sulphur
reducing bacteria
a. Unit backwashed thoroughly at install.
(backwash now)
b. Check backwash control
c. Plugged backwash control
d. Kinked drain line
a. Fasten all lines
a. Broken distributor or riser tube.
17
Advertisement
Table of Contents
