Water Depot ECONO Series Owner's Manual page 11

Regeneration Mode
Typically a system is set to regenerate at a time of low water usage. An example of a time with
low water usage is when a household is asleep. If there is a demand for water when the system
is regenerating, untreated water will be used.
When the system begins to regenerate, the display will change to include information about the step of the regeneration
process and the time remaining for that step to be completed. The system runs through the steps automatically and will
reset itself to provide treated water when the regeneration has been completed.
Manual Regeneration
Sometimes there is a need to regenerate the system sooner than when the
system calls for it, usually referred to as manual regeneration. There may
be a period of heavy water usage because of guests or a heavy laundry
To initiate a manual regeneration at the preset delayed regeneration time, when
the regeneration time option is set to "NORMAL" or "NORMAL + on 0",
press and release "REGEN". The words "REGEN TODAY" will flash on the
display to indicate that the system will regenerate at the preset delayed regeneration time. If you pressed the "REGEN"
button in error, pressing the button again will cancel the request. Note: If the regeneration time option is set to "on 0" there
is no set delayed regeneration time so "REGEN TODAY" will not activate if "REGEN" button is pressed.
To initiate a manual regeneration immediately, press and hold the "REGEN" button for three seconds. The system will
begin to regenerate immediately. The request cannot be cancelled.
Note: For softeners, if the brine tank does not contain salt, fill with salt and wait at least two hours before regenerating.
Set Time of Day
The user can also set the time of day. Time of day should only need to be set after extended power outages or when
daylight saving time begins or ends. If an extended power outage occurs, the time of day will flash on and off which
indicates the time of day should be reset.
Power Loss
If the power goes out for less than two hours, the system will automatically reset
itself. If an extended power outage occurs, the time of day will flash on and off which
indicates the time of day should be reset. The system will remember the rest.
Error Message
If the word "ERROR" and a number are alternately flashing on the display contact the
for help. This indicates that the valve was not able to function properly.
STEP 1U – Press CLOCK.
STEP 2U - Current Time (hour): Set the hour of the day using  or  buttons. AM/PM
toggles after 12.
Press NEXT to go to Step 3U.
STEP 3U - Current Time (minutes): Set the minutes of the day using  or  buttons. Press
NEXT to exit
Set Time of Day. Press REGEN to return to previous step.
STEP 2U
STEP 3U
11