Datamax I-Class Mark II Operator's Manual page 23

4. Load m edia as described in sect ion 2.2. Feed approxim at ely 20 inches ( 50 cm ) of m edia out
of t he print er. Rout e t he m edia over t he Arc Plat e and t hen back int o t he print er and around
t he Rewinder Hub.
5. Wrap t he m edia around t he Rewinder Hub. I nsert t he end of t he m edia int o a Slot in t he
Rewinder Hub. Slide t he Media Ret ainer int o t he Slot t o secure t he m edia.
6. Rot at e t he Rewinder Hub by hand t o t ake up any slack in t he m edia. There should be at least
2 or 3 full wraps of t he m edia on t he Rewinder Hub before st art ing print ing t o ensure t ight
rewinded rolls.
Ch a pt e r 2 - Pr int e r Se t u p

Arc Plat e

Rewinder Hub

Media

Rewinder Hub

Media Ret ainer

Slot
1 7