Parameter
Parameter description
G42
S05
G45
G46
G55
Parameter
Parameter description
A19
L02
S11
Parameter
Parameter description
G08
Compressor and fan status with open door
R07
Digital input 3 configuration
G53
Maximum time with open door before alarm goes off
R08
Table 35: Additional features for customization
AGL_Unit_ZX_A2L_E_Rev00
Evaporator fan – System restart is required!
Fans operating mode
Relay output 2
Fan on time
Fan off time
Fan delay after defrost
System EXV – System restart is required!
Probe 7 configuration
Set of superheating
EXV configuration
Door switch – System restart is required!
Digital input 3 polarity
Factory setting
cn = Switch on and off with the compressor, stop
during defrost
On = Always on, stop during defrost
cn
cy = Switch on and off with the compressor, run
during defrost
Oy = Always on, run during defrost
nu = Not used
1 min
Adjust to application requirements
1 min
Adjust to application requirements
1 min
Adjust to application requirements
Factory setting
nu = Not used
5
uin or Lin
Factory setting
Fn
nu = Not used
3 min
Adjust to application requirements
CL = Closed
Adjust to application requirements
Required setting
EPF = Evaporator fan
Required setting
SLt = Suction line temp
7
SHt = System superheat
Required setting
nO = Normal operation
Fn = Stop fan
cP = Compressor off
Fc = Compressor and fans off
dOr = Door
59