Analogue total (optional)
14.2 Selection of the sensor type
See also Chapter
7.3.2.1.2.8 Konfiguration von Analogsensoren
Main menu Settings Sensor settings C1
Main menu Settings Sensor settings C1 Type text field
Messwert
Note:
The text field "unit-consumption rate" is only editable in case of measurement values (units) with volume or
amounts per time unit and thus also the consumption calculation.
For the marking and setting of the text fields see also Chapter
len
82
Einheit
Verbrauchsmenge
Selection of the required sensor type by press-
ing the respective button, here, for example 4-
20 mA.
Confirmation and acceptance with the
button.
Selection of the units by pressing the respec-
tive
unit, Measured value
rate
text
fields.
Enter scale values for 4 mA and 20 mA, here
0 m³/h and 170m³/h.
If required, it is possible to enter a start value
for the consumption rate, for the takeover of a
counter reading. For this, enter the value into
the
Set total to
text
field.
Confirmation of the entries by pressing the
button.
7.3.2.1.2.7 Textfelder beschriften und einstel-
OK
or
Consumption
OK
®
METPOINT
BDL portable