Wall Mounting The Temperature Station And/Or Outdoor Sensor - Auriol AFT 77 B2 Operating Instructions Manual

♦ The temperature station and the outdoor sensor can either be
placed on a flat, horizontal surface or hung on a screw using
the hanger z or s.
♦ Unfold the stand j on the outdoor sensor to stand it up.
If necessary, protect sensitive surfaces by using a mat.
Wall mounting the temperature station and/
or outdoor sensor
You will need a drill, a 5 mm drill bit and a Phillips screwdriver for
the assembly.
DANGER
► Make sure that you do not hit any power lines or gas or water
pipes when you drill into the wall. There is a risk of injury!
ATTENTION
► The supplied wall plugs are only suitable for mounting in
concrete or stone. Before starting, please check that your
installation location is suitable for the wall plugs. If in doubt,
consult a professional.
♦ Mark the drill hole on the wall.
♦ Drill the hole at the marked position using an electric drill and
a 5 mm drill bit to a depth of at least 25 mm.
♦ Insert the wall plug into the hole.
♦ Screw the screw into the wall plug using a Phillips screwdriver.
Make sure that the screw head protrudes approx. 3 mm.
♦ Hang the temperature station or outdoor sensor using the
hanger z or s.
│ GB │ CY
■ 10
AFT 77 B2