Table of Contents
Advertisement
Cleaning the water inlet filter
A filter is incorporated in the screw
connection to protect the water intake
valve. The filter must be cleaned when
dirty, otherwise insufficient water flows
into the wash cabinet.
The plastic housing of the water
connection contains an electrical
valve.
The housing must not be dipped in
water.
Recommendation
If the water supply contains a large
number of insoluble substances, we
recommend fitting a large-area filter in
the connection between the stopcock
and the safety valve threaded union.
This water filter is available from a Miele
dealer or from the Miele Customer
Service Department.
To clean the filter:
Disconnect the dishwasher from the
mains.
To do this, turn off the dishwasher,
switch off at the socket and unplug it.
Close the stopcock.
Unscrew the water intake valve.
Remove the seal from the screw
thread.
Withdraw the filter using combination
or pointed pliers and rinse clean
under running water.
Refit the filter and seal. Make sure
they are fitted correctly.
Screw the water intake valve to the
stopcock. Make sure not to cross-
thread the connection.
Open the stopcock.
If water leaks out, the screw connection
may not be connected securely or it
may have been screwed on at an angle.
Fit the water intake valve straight and
screw it in place.
Maintenance
65
Advertisement
Table of Contents
