Table of Contents
Advertisement
Before using for the first time
Filling the salt reservoir
Before filling the salt reservoir for the
first time, you must fill it with approx.
1 l of water to enable the salt to dis-
solve.
Once the dishwasher has been used,
there is always sufficient water in the
reservoir.
Remove the lower basket from the
wash cabinet and unscrew the salt
reservoir cap.
Risk of corrosion due to saline
solution.
Water or saline solution will run out
of the reservoir when the cap is
opened. Saline solution that runs out
can cause corrosion in the wash
cabinet and to the load items.
The salt reservoir should therefore
only be opened in order to replenish
the salt.
Fill the salt reservoir with approx. 1 l
of water (first use only).
26
Place the funnel provided over the
salt reservoir and carefully fill with
dishwasher salt until the reservoir is
full. The salt reservoir holds up to
1 kg of salt, depending on the type of
salt used.
Clean off salt residues from around
the salt reservoir opening. Next,
screw the salt reservoir cap on again
firmly.
Immediately after filling the salt reser-
voir and each time you remove the
salt container cap, run the
65 °C QuickPowerWash pro-
gramme with the Express pro-
gramme option selected without any
load items in the dishwasher to dis-
solve and remove any traces of salt
from the wash cabinet.
Advertisement
Table of Contents
