Universal Garage Door Opener; (Homelink®) - If Equipped; Homelink; Erasing All The Homelink® Channels - RAM Commercial CHASSIS CAB 3500 2021 Owner's Manual

CAUTION!
It is recommended to fold the mirrors into the
full rearward position to resist damage when
entering a car wash or a narrow location.

UNIVERSAL GARAGE DOOR OPENER

(HOMELINK®) — IF EQUIPPED
HomeLink® Buttons
HomeLink® replaces up to three hand-held

transmitters that operate devices such as
garage door openers, motorized gates,
lighting, or home security systems.
The HomeLink® unit is powered by
your vehicles 12 Volt battery.
The HomeLink® buttons that are located in

the overhead console or sunvisor designate
the three different HomeLink® channels.
To operate HomeLink®, push and release

any of the programmed HomeLink® buttons.
These buttons will activate the devices they
are programmed to with each press of the
corresponding HomeLink® button.
The HomeLink® indicator light is located

above the center button.
B Y B P
EFORE OU EGIN ROGRAMMING
H L ®
OME INK
For efficient programming and accurate
transmission of the radio frequency signal, it is
recommended that a new battery be placed in
the hand-held transmitter of the device that is
being programmed to the HomeLink® system.
Make sure your hand-held transmitter is
programmed to activate the device you are
trying to program your HomeLink® button to.
Ensure that your vehicle is parked outside of the
garage before you begin programming.
It is recommended that you erase all the
channels of your HomeLink® before you use it
for the first time.
GETTING TO KNOW YOUR VEHICLE
E A T H L
RASING LL HE OME INK
C
HANNELS
To erase the channels, follow this procedure:
1. Place the ignition switch into the ON/RUN
position.
2. Push and hold the two outside HomeLink®
buttons (I and III) for up to 20 seconds, or
until the HomeLink® indicator light flashes.
NOTE:
Erasing all channels should only be performed
when programming HomeLink® for the first
time. Do not erase channels when programming
additional buttons.
I W Y
DENTIFYING HETHER OU
R C O N -R
OLLING ODE R ON OLLING
D
EVICE
Before programming a device to one of your
HomeLink® buttons, you must determine
whether the device has a rolling code or
non-rolling code.
47
®
2
H A
AVE
C
ODE