Turning Lanesense On Or Off; Lanesense Warning Message - RAM Commercial CHASSIS CAB 3500 2021 Owner's Manual

184 STARTING AND OPERATING
T L S O
URNING ANE ENSE N
The LaneSense button is located on
the switch panel below the Uconnect
display.
NOTE:
If your vehicle is equipped with a 12–inch
Uconnect Display screen, the LaneSense button
is located above the display.
To turn the LaneSense system on, push the
LaneSense button (LED turns off). A "LaneSense
On" message is shown in the instrument cluster
display.
To turn the LaneSense system off, push the
LaneSense button again (LED turns on).
NOTE:
The LaneSense system will retain the last
system state (on or off) from the last ignition
cycle when the ignition is changed to the
ON/RUN position.
O O L S
R FF ANE ENSE
The LaneSense system will indicate the current
lane drift condition through the instrument
cluster display.
When the LaneSense system is on, the lane
lines are gray when both of the lane boundaries
have not been detected and the LaneSense
telltale
System ON (Gray Lines) With White Telltale
Left Lane Departure — Only Left Lane Detected
When the LaneSense system is on, the Lane-

Sense Telltale
left lane marking has been detected and the
system is ready to provide visual warnings in
the instrument cluster display if an uninten-
tional lane departure occurs on the left side.
W M
ARNING ESSAGE
is solid white.
is solid white when only the
When the LaneSense system senses the lane

has been approached and is in a lane depar-
ture situation, the visual warning in the
instrument cluster display will show the left
lane line flashing yellow (on/off). The Lane-
Sense telltale changes from solid white to
flashing yellow.
Lane Crossed (Flashing Yellow Lane Line) With Yellow
Telltale
NOTE:
The LaneSense system operates with similar
behavior for a right lane departure when only
the right lane marking has been detected.