RAM Commercial CHASSIS CAB 3500 2021 Owner's Manual page 280

278 SAFETY
The ESC Activation/Malfunction Indicator Light
starts to flash as soon as the tires lose traction
and the ESC system becomes active. The ESC
Activation/Malfunction Indicator Light also
flashes when TCS is active. If the ESC Activation/
Malfunction Indicator Light begins to flash during
acceleration, ease up on the accelerator and
apply as little throttle as possible. Be sure to
adapt your speed and driving to the prevailing
road conditions.
The ESC OFF Indicator Light indicates
that the Electronic Stability Control
(ESC) is in a reduced mode.
NOTE:
The ESC Activation/Malfunction Indicator

Light and the ESC OFF Indicator Light come
on momentarily each time the ignition is
placed in the ON position.
Each time the ignition is placed in the ON

position, the ESC system will be on even if it
was turned off previously.
The ESC system will make buzzing or clicking

sounds when it is active. This is normal; the
sounds will stop when ESC becomes inactive
following the maneuver that caused the ESC
activation.
Hill Descent Control (HDC) — If Equipped
HDC is intended for low speed off-road driving
while in 4WD Low. HDC maintains vehicle speed
while descending hills during various driving
situations. HDC controls vehicle speed by
actively controlling the brakes.
HDC Has Three States:
1. Off (feature is not enabled and will not
activate).
2. Enabled (feature is enabled and ready but
activation conditions are not met, or driver
is actively overriding with brake or throttle
application).
3. Active (feature is enabled and actively
controlling vehicle speed).
Enabling HDC
HDC is enabled by pushing the HDC switch, but
the following conditions must also be met to
enable HDC:
The driveline is in 4WD Low.

The vehicle speed is below 5 mph (8 km/h).

The parking brake is released.

The driver door is closed.

Activating HDC
Once HDC is enabled it will activate
automatically if driven down a grade of
sufficient magnitude. The set speed for HDC is
selectable by the driver, and can be adjusted by
using the gear shift +/-. The following
summarizes the HDC set speeds:
HDC Target Set Speeds
P = No set speed. HDC may be enabled but

will not activate.
R = 0.6 mph (1 km/h)

N = 1.2 mph (2 km/h)

D = 0.6 mph (1 km/h)

1st = 0.6 mph (1 km/h)

2nd = 1.2 mph (2 km/h)

3rd = 1.8 mph (3 km/h)

4th = 2.5 mph (4 km/h)

5th = 3.1 mph (5 km/h)

6th = 3.7 mph (6 km/h)

7th = 4.3 mph (7 km/h)
