Toshiba RD-X2U Owner's Manual page 91

To delay the end time while recording
Press the EXTEND button under the lid of the
remote control.
When you press it once, the current end time appears.
Each time you press the button, the end time
(displayed in the indication section) is delayed in 10
minutes increments, up to 60 minutes.
Notes
• Pressing any button other than the EXTEND button
completes this procedure to determine the end time.
• This operation must be performed prior to 1 minute before
the programmed end time.
• A recording automatically finishes when the disc is full or
when the recording exceeds 9 hours regardless of whether
or not you delayed the end time.
To play a title recorded on the HDD while
recording on the HDD (Recorded Title Play in
HDD)
HDD
This function works only during HDD recording.
You cannot play a title recorded on a DVD-RAM disc
sinultoneously with DVD-RAM recording.
1) While recording on the HDD, press the
CONTENT MENU button.
2) Press the / /
desired title, then press the ENTER button.
Playback of the selected title starts.
Pressing the STOP button stops playback, and the
content that is being recorded appears on the
display. If you press the PLAY button, playback
resumes from the location you last stopped.
Note
• While you are using this function, the following operations/
functions are not available.
- Dividing chapters. (By the CHP DIVIDE button)
- Programmed playback (Repeat playback, etc.)
- Editing (Chapter dividing, Playlist programming, dubbing,
title naming, title thumbnail setting, intro scan)
• While performing relay recording (
function is not available.
Entering the recording format on the DVD-R
Before recording, make sure "DVD-R Broadcast
Record" is set to "Main" or "SAP" (
*RD-X2.Ope(US)p027-044
/ buttons to select a
page 70), this
page 128).
39
Notes
• You cannot close the disc tray automatically at the
recording start time. If you want to record on a DVD-RAM
disc, load it on the recorder beforehand.
• While recording, you cannot change the settings of a
program, such as the channel, mode, etc.
• The number of titles cannot exceed in any case 99 for a
DVD-RAM and 198 for the HDD.
• You cannot record on both an HDD and a DVD-RAM disc
at the same time (except relay recording).
• The maximum length of a recording is 9 hours. Recording
automatically stops when length exceeds 9 hours.
• While performing a programmed recording, you cannot
program a new timer selection.
• You may not be able to start recording if there is too little
time before a programmed recording begins.
• A programmed recording may not be executed if a power
failure occurrs within 5 minutes before the start time.
• If an HDD starts programmed recording while you are
playing a DVD-drive disc, the picture may pause
momentarily.
• When you record monaural sound, the same sound is
recorded to both left and right channel.
• When you record a bilingual program in the "L-PCM" mode
( page 35), the sound is recorded as stereo. In this
case, both the main and sub sound will be output at the
same time. Select the output sound by pressing the INPUT
SELECT button.
• When you record content which will be dubbed on a DVD-
R, be sure to set "DVD-R Broadcast Record" to "Main" or
"SAP" ( page 128).
• To select SAP, set "SAP" to "on" (
• When you set "DVD-R Broadcast Record" to "Main" or
"SAP" ( page 128), only the selected sound of the
bilingual program (main or sub) is recorded.
• When you set "DVD-R Broadcast Record" to "Main" or
"SAP" ( page 128), only the selected sound of the
bilingual program is recorded. To prevent this, set "DVD-R
Broadcast Record" only when you record content that will
be dubbed to a DVD-R.
9/3/02, 11:23 AM
page 124).
39