Starting Up The Recorder - Toshiba RD-X2U Owner's Manual

Basic Setup

Starting up the recorder

After all the necessary connections,
• Turn on the equipment connected to the
recorder.
• Select the corresponding video input on
your television.
Perform these selections whenever you operate
the recorder.
Turning the power on
Press the power button from the remote control or on
the front panel of the recoder.
ON/STANDBY indicator
Power button
OPEN/CLOSE
DVD
TOP MENU MENU RETURN
ANGLE SUBTITLE AUDIO CHANNEL
HDD HDD TIMESLIP DVD DVD
V-REMOTE INSTANT REPLAY INSTANT SKIP
REC MENU
EDIT MENU
LIBRARY CONTENT MENU
ENTER ENTER
When the power turns on, the ON/STANDBY indicator
changes color from red (standby mode) to green
(operation).
After a few seconds, a startup screen appears.
The following icon will appear on the top right corner
of the screen. The icon will continue flashing
momentarily.
e.g.
26
RD-X2U.Prep.(E)p25-39
Power button
Loading
26
While the icon is flashing, the recorder is checking
the status and reading data of the HDD and DVD-
RAM drive for startup. If the DVD-RAM drive does
not contain a disc, the recorder consumes less
time to startup, because it does not need to read
data from the DVD-RAM drive.
While the "Loading" icon is flashing, the recorder
cannot respond to any operations of buttons other
than CHANNEL and INPUT SELECT. Operate all
other functions after the icon has disappeared.
Note
When the recorder is turned on for the first time, the
following menu will be displayed after the "Loading" icon has
disappeared. See "A: Initial Settings" (
e.g.
Initial Settings
Time & Date Setting
TV/CATV
Channel Setting
Guide Channel Setting
Cable Box/DSS
Output Channel
DVD-RAM Physical Format
HDD Format
Select Return
Turning the power off
Press the power button from the remote control or on
the front panel of the recoder.
The "Unloading" icon appears on the right corner of
the top of the screen, and the ON/STANDBY indicator
turns red. Then the power turns off.
Note
If the recorder freezes for about 15 minutes and will not
respond to any buttons, holding down the ON/STANDBY
button on the front panel for about 10 seconds can force the
recorder to turn off. However, this is an emergency measure,
which contains a risk of damage to data or discs. Avoid
casual use of this measure. If you try this while the recorder
is operating properly, especially while the "Loading" or
"Unloading" icon is flashing, it may result in re-initialization of
the HDD.
9/3/02, 9:47 AM
page 28).
Auto
TV
No Use
3CH
SETUP SETUP SETUP
Exit
Set