Assembling The Drum Unit - Brother TN-210 Series Remanufacturing Instructions

ASSEMBLING THE DRUM UNIT

STEP 6.1
DRIVE SIDE
c
orrect
P
osition
Before installing the drum, ensure the stabilizer ring
is positioned correctly on the drive side (Figure 6.1A).
STEP 6.2
DRIVE SIDE
Place the drum into the drive side of the drum unit first
(Figure 6.2).
Tab
Visit Static Control on the web @ www.scc-inc.com
®
DRIVE SIDE
i
ncorrect
Stabilizer Ring
P
FIGURE 6.1A
STEP 6.3
FIGURE 6.2
Slide the locking bearing into the drum hub (Figure 6.3A).
Secure the locking bearing by aligning the tab on the locking
bearing with the opening in the drum hub (Figure 6.3B).
STEP 6.4
Locking
Bearing
FIGURE 6.3B
After applying fresh conductive lubricant in the area shown in
Figure 6.4, place the drum axle locking clip onto the drum and
slide the axle into the contact side of the drum.
osition
Note: Incorrect position of the drum stabilizer will
prevent the corona assembly from installing
properly (Figure 6.1B).
Tab
Conductive
Lubriacant
SSS 1127
™
Stabilizer
Ring
FIGURE 6.1B
Locking
Bearing
Needle
Nose
Pliers
FIGURE 6.3A
CONTACT SIDE
Locking
Bearing
C-Clip
FIGURE 6.4
1127 | 16
SSS
™