Brother TN-210 Series Remanufacturing Instructions page 7

DISASSEMBLING THE CARTRIDGE
STEP 2.7
Small Slotted
Screwdriver
Using a small slotted screwdriver, remove the contact side
developer roller support bearing and spring (Figure 2.7).
STEP 2.8
Phillips
Screwdriver
On the contact side end plate, remove the screw (Figure 2.8).
2.10
Locking
Tab
To remove the developer roller, insert a small slotted screwdriver
into the small opening as shown in Figure 2.10 and gently pry
the white developer roller stabilizer's locking tab loose.
Visit Static Control on the web @ www.scc-inc.com
®
Contact Side
Developer Roller
Support Bearing
& Spring
FIGURE 2.7
STEP 2.9
Screw
FIGURE 2.8
Remove the contact side end plate (Figure 2.9).
STEP 2.11
Small Slotted
Screwdriver
FIGURE 2.10 FIGURE 2.10
Remove the developer roller from the cartridge (Figure 2.11)
Note: Insert a small slotted screwdriver under the contact
side support bearing, then lift up and out to
free the developer roller support bearing from
the cartridge. Remove the spring.
Note: Clean the developer roller with a lint-free cleaning cloth
saturated in 91-99%
use another lint-free cloth with de-ionized water
and blow dry with dry, filtered, ionized compressed air.
SSS 1127
™
Contact Side
End Plate
FIGURE 2.9
FIGURE 2.11
isopropyl alcohol. Then
1127 | 7
SSS
™