Table of Contents
Advertisement
3.3
Installation Procedures
3.3.1 Install the printer onto the lower tray unit
1) Place the lower tray unit on a solid, flat surface where the printer is to be installed
ensuring that the conditions in
2) Check that the set-up guides R/L are fixed onto the lower tray unit.
Set-up Guide (L)
3) Pull out the LT signal connector which is located at the rear left side of the unit, and
remove the LT connector cover from the lower tray unit.
sections 3.1.1
and
3.1.2
Fig. 4
Fig. 5
- 5 -
are complied with.
Set-up Guide (R)
LT Signal Connector
LT connector cover
INSTALLATION
Advertisement
Table of Contents
