Brother TN-210 Series Remanufacturing Instructions page 17

ASSEMBLING THE DRUM UNIT
STEP 6.5
Drum
Stabilzer
Ring
Place the drum stabilizer ring onto the drum axle (Figure 6.5A) and
then snap the locking retainer onto the drum axle (Figure 6.5B).
STEP 6.6
Place the corona assembly onto the drum section (Figure 6.6A)
ensuring the tabs are aligned. When done correctly, the corona
assembly will seat flush to the rest of the drum unit (Figure 6.6B).
Note: If the tabs are not properly aligned, an error
message "print unable..." will appear during use
(Figure 6.6C).
Visit Static Control on the web @ www.scc-inc.com
®
Drum
Axle
FIGURE 6.5A
Corona Assembly
FIGURE 6.6A
a
i
ncorrectly
FIGURE 6.6C
Drum
Stabilzer
Ring
STEP 6.7
t
aBs
ligned
Using a Phillips screwdriver, secure the corona assembly onto
the drum unit with two screws (Figure 6.7).
SSS
™
C-Clip
Drum
Axle
FIGURE 6.5B
a
c
orrectly
FIGURE 6.6B
Phillips
Screws
Screwdriver
FIGURE 6.7
SSS
™
1127
t
aBs
ligned
1127 | 17