ASSEMBLING THE CARTRIDGE
STEP 3.7
Place the contact side end cap and secure with a screw
(Figures 3.7A and 3.7B).
STEP 3.8
Place the contact side developer roller support spring and
bearing onto the developer roller axle (Figure 3.8).
STEP 3.9
Drive Side Support Bearing Tabs
Place the drive side end cap onto the cartridge and ensure that
the drive side support bearing tabs are on the outer part of the
drive side end plate (Figure 3.9).
Visit Static Control
on the web @ www.scc-inc.com
®
Contact
Side End
Cap
FIGURE 3.7A
Contact Side
Developer Roller
Support Bearing
FIGURE 3.8
STEP 3.10
B
FIGURE 3.9
Use a small slotted screwdriver to gently set the foam under
the drive side developer roller support bearing back into place
(Figures 3.10A and 3.10B).
Note: Reference Figures 4.1A and 4.1B on page 13
under the "Resetting the Flag Gear" section, to
ensure the flag gear tab is in the reset location
prior to placing the drive side end cap onto the
cartridge. Print error failures could result if the
gear is not set properly.
efore
Foam
FIGURE 3.10A
SSS
1127
™
Screw
FIGURE 3.7B
a
fter
No Foam
FIGURE 3.10B
1127 |
SSS
™
11