Resetting The Flag Gear - Brother TN-210 Series Remanufacturing Instructions

RESETTING THE FLAG GEAR

STEP 4.1
Note: Reference Figures 4.1A and 4.1B to ensure the
flag gear tab is in the reset location. Print error
failures could result if the gear is not set properly.
STEP 4.2
Install the flag gear spring as shown in Figure 4.2.
Note: The short arm of the spring needs to be on the left
side of the cartridge post as shown in Figure 4.3
Visit Static Control on the web @ www.scc-inc.com
®
Flag Gear
Tab Spent
Position
FIGURE 4.1A
Cartridge Post
Flag Gear
Spring Arm
Behind
Cartridge
Post
FIGURE 4.2
STEP 4.3
The spring should rest on the flag gear. Using a small slotted
screwdriver, press spring down onto the post (Figure 4.3).
SSS 1127
™
Flag Gear
Tab Reset
Position
FIGURE 4.1B
Small Slotted
Screwdriver
FIGURE 4.3
1127 | 13
SSS
™