BROTHER is either a trademark or a registered trademark of Brother Industries, Ltd. Any trade names and product names of companies appearing on Brother products, related documents and any other materials are all trademarks or registered trademarks of those respective companies.
Collects standard, non-stapled print jobs The Stapler Finisher (SF) unit adds new paper output functions to your Brother machine, such as stapling, offsetting, and stacking. You can select these functions in the printer driver, from your Brother machine’s LCD, or using the machine's Web Based Management.
Click OK. From the machine's LCD: a) On the machine’s LCD, press [Settings] > [Paper Tray] > [Output Tray]. b) Press [SF] or [SF Stacker]. For non-standard printer drivers only. Not required for the users of the standard Brother printer driver.
・ You can activate the Staple and Offset functions at the same time. From the machine's LCD: a) On the machine’s LCD, press [Settings] > [Paper Tray] > [Staple] or [Offset]. b) Press [On] or [Off]. For non-standard printer drivers only. Not required for the users of the standard Brother printer driver.
1.3 Prioritize Printing Using the SF Continue Mode The SF Continue Mode allows you to continue printing when the selected paper size or media type is not supported by the Stapler Finisher. Setting Description The machine continues to print without stapling or offsetting, or prints out to the Standard Output Tray.
When staples need to be replaced, an error message appears on the machine’s LCD or in the Status Monitor. We recommend purchasing the following Staple Cartridge: Name Order No. Staple Cartridge SR100 For more information about the staples, visit www.brother.com/original or contact your local Brother dealer.
2.2 Replace the Staple Cartridge When the message “Add Staples” appears on the machine’s LCD, there are fewer than 20 staples remaining and you must replace the Staple Cartridge: 1. Open the Staple Cover. 2. Remove the Staple Cartridge. 3. Remove the empty Staple Cartridge Case.
4. Unpack a new Staple Cartridge Case. 5. Attach the new Staple Cartridge Case onto the Staple Cartridge. 6. Insert the Staple Cartridge into the Stapler Finisher. 7. Close the Staple Cover.
3. Troubleshooting This chapter explains how to resolve typical problems you may encounter when using the Stapler Finisher with your Brother machine. 3.1 Paper and Staple Jams When the message “Finisher Jam” appears on the machine’s LCD or in the Status Monitor, you must clear any paper or staple jams in the Stapler Finisher unit: 1.
4. Gently remove any jammed paper from the Stapler Finisher unit. 5. Close the Finisher Rear Cover. 6. Open the Staple Cover. 7. Remove the Staple Cartridge.
8. Lift the Staple Cartridge latch. 9. Remove any jammed staples. 10. Lock the Staple Cartridge latch into its original position. 11. Reinsert the Staple Cartridge into the Stapler Finisher. 12. Close the Staple Cover.
3.2 Error and Maintenance Messages As with any sophisticated office product, errors may occur and supply items may have to be replaced. If this happens, your machine will display the error or required routine maintenance notification on the LCD. The most common error and maintenance messages are shown in the table.
The Stapler Finisher has a • Press and hold to turn off mechanical problem. the machine, wait a few minutes, and then turn it on again. • If the problem continues, contact Brother Customer Service or your local Brother dealer.
Visit us on the World Wide Web global.brother Version 0...