Brother TN-210 Series Remanufacturing Instructions page 15

DISASSEMBLING THE DRUM UNIT
STEP 5.4
CONTACT SIDE
Small
Slotted
Screwdriver
Use a small, slotted screwdriver to press the tab on the locking
bearing (Figure 5.4A) and remove the bearing using needle
nose pliers (Figure 5.4B).
STEP 5.5
CONTACT SIDE
Push the drum axle on the contact side of the drum unit toward
the drive side until the small white locking retainer and black
stabilizer ring are visible (Figure 5.5).
STEP 5.7
Remove the spent drum by rotating and pulling upwards
(Figure 5.7).
Visit Static Control on the web @ www.scc-inc.com
®
CONTACT SIDE
Tab on
Locking
Bearing
FIGURE 5.4A
STEP 5.6
DRIVE SIDE
Locking
Retainer
FIGURE 5.5
Remove the drum axle from the drum unit (Figure 5.6).
Remove the white locking retainer and black stabilizer ring
from the drum axle and set them aside.
STEP 5.8
FIGURE 5.7
Clean the drum unit, transfer roller and corona assembly with
dry, filtered, ionized, compressed air (Figure 5.8).
Note: Be careful not to lose any of the smaller parts
Drum Axle
Drum Unit
while cleaning the drum unit.
SSS 1127
™
Locking
Bearing
Needle
Nose
Pliers
FIGURE 5.4B
DRIVE SIDE
Locking
Retainer
Stabilizer
Ring
FIGURE 5.6
Compressed
Air
FIGURE 5.8
1127 | 15
SSS
™