Video Selfview Default Pipposition; Video Selfview Mirrored; Video Selfview Oncall Duration; Video Selfview Oncall Mode - Cisco Webex DX70 Administrator's Manual

Cisco Webex DX70 and DX80

Introduction

Video Selfview Default PIPPosition

Define the position on screen of the small self-view picture-in-picture (PiP) after a call.
The setting only takes effect when self-view is switched on (see the Video Selfview
Default Mode setting) and fullscreen view is switched off (see the Video Selfview Default
FullscreenMode setting).
Requires user role: ADMIN, INTEGRATOR
Default value: Current
Value space: Current/UpperLeft/UpperCenter/UpperRight/CenterLeft/CenterRight/
LowerLeft/LowerRight
Current: The position of the self-view PiP will be kept unchanged when leaving a call.
UpperLeft: The self-view PiP will appear in the upper left corner of the screen.
UpperCenter: The self-view PiP will appear in the upper center position.
UpperRight: The self-view PiP will appear in the upper right corner of the screen.
CenterLeft: The self-view PiP will appear in the center left position.
CentreRight: The self-view PiP will appear in the center right position.
LowerLeft: The self-view PiP will appear in the lower left corner of the screen.
LowerRight: The self-view PiP will appear in the lower right corner of the screen.

Video Selfview Mirrored

You can configure the device to show the self-view image the way other people see you, or
as you would see yourself in a mirror.
This setting has no effect on the video that is sent to the far end.
Requires user role: ADMIN, INTEGRATOR
Default value: On
Value space: Off/On
Off: Display the self-view image as other people see you.
On: Display the self-view image as you see yourself in a mirror.
D15362.16 DX70 and DX80 Administrator Guide CE9.13, JUNE 2020.
Configuration Peripherals Maintenance

Video Selfview OnCall Mode

This setting is used to switch on self-view for a short while when setting up a call. The
Video Selfview OnCall Duration setting determines for how long it remains on. This applies
when self-view in general is switched off.
Requires user role: ADMIN, INTEGRATOR
Default value: On
Value space: Off/On
Off: Self-view is not shown automatically during call setup.
On: Self-view is shown automatically during call setup.

Video Selfview OnCall Duration

This setting only has an effect when the Video Selfview OnCall Mode setting is switched
On. In this case, the number of seconds set here determines for how long self-view is
shown before it is automatically switched off.
Requires user role: ADMIN, INTEGRATOR
Default value: 10
Value space: Integer (1..60)
Range: Choose for how long self-view remains on. The valid range is between 1 and 60
seconds.
www.cisco.com — Copyright © 2020 Cisco Systems, Inc. All rights reserved.
188
Administrator Guide
Device settings Device settings Appendices