Troubleshooting; Restore To Factory Default - Cisco SCH-7IN-TS-B/W Reference Manual

Troubleshooting

Configure in Composer Pro
When the touchscreen is physically installed and appears on the residential network, you can add and
configure it for the System using Composer Pro. Choose the In-Wall 7" Touch Screen V2 driver in
Composer Pro and add it to your project.
See the
Troubleshooting
Boot Up
When the device is booting up, it may take 30 seconds or longer before the Green LED turns on. When
it turns on, it blinks slowly for a time and then turns off. After that, you will see an image on the
touchscreen.

Restore to Factory Default

If the camera's LED blinks on and off for more than 30 seconds, the device will need to be restored.
To access the Factory Restore switch, you'll first need to remove the touchscreen.
If there's tape on the bottom of the power box, simply lift the touchscreen off. Remove the tape to lock
Note
the touchscreen in place. If there's no tape, the touchscreen is locked into place. In this case, follow the
instructions below.
Step 1 Locate the small hole underneath the touchscreen's faceplate (see
Figure 12
1
2
3
Cisco Smart+Connected 7" In-wall Display Reference Guide
16
Cisco Smart+Connected Residential Installation and Configuration Guide
Touchscreen Underside - Pin and Pinhole
Speaker
Insert paper clip here to remove touchscreen
Security pin
for more information.
Figure 12 through Figure 15).
OL-27263-01